drip legs – What Is Piping

What is a Drip Leg in Steam Piping? Drip Legs are vertical piping pockets installed in steam piping to collect condensate. Installing drip legs in the proper location serves the purpose of a successful, water-hammer free, system start-up. Purpose of Drip Legs Drip Legs are installed in steam mains to serve following purposes: Drip Legs are used for removing entrained moisture from the steam transmission and distribution lines to ensure high-quality steam for use in various plant applications, while also preventing damaging and dangerous water hammer.As steam travels at high velocity through piping, moisture forms as the result of piping heat losses and/or improper boiler control resulting in condensate carryover.Drip legs are therefore located at points where condensate may accumulate to allow for drainage by gravity down to a steam trap for proper discharge from the system. Since condensate drains by gravity, drip legs must be located on the bottom of piping and designed with diameters large enough to promote the collection. Drip Leg Installation guidelines Due to heat loss and system start up energy consumption, condensate is formed inside the steam pipes. For proper working of the steam system this condensate must be drained by installing drip legs in main lines at appropriate locations. Drip legs should be located at Vertical Lifts, Drops, or at the end of the steam line.In the straight run of piping every 30 to 50 meters.Installed directly ahead of the regulating or control valve, Manual Valves Closed for a Long Time.Ahead of expansion joints or elbows.Provide proper supports (no sagging)Provide slope towards Drip legs. Drip Leg Categories DRIP Applications: drip trapsPROCESS Applications: process trapsTRACING Applications: tracer traps. Steam tracing refers to using steam to indirectly elevate the temperature of a product using jacketed pipes or tubing filled with steam Drip Leg Configuration Because condensate drainage from steam systems is dependent upon gravity, drip leg (Fig. 1) diameter is critical for optimum removal – larger is better. Fig. 1: Figure of a properly configured drip leg. Fig. 2 below shows a typical loop used in a drip leg. Fig. 2: Typical Drip Leg Loops from Steam Mains Selection of Drip Leg Sizes The selection of drip leg sizes for draining the main steam line depends on the types of warm-up methods as mentioned below: Supervised Warm-up Method: Warming up of the power plant principal piping normally follows this method. Such lines are warmed up only once in a lifetime and hence long drip leg is not required.Automatic Warm-Up Method: Such warm-up method is used for frequent steam use leading to the requirement of bigger drip legs. A static head (dimension H in Fig. 2) is used in such cases. Fig. 3 below provides the recommended Drip leg Sizes (Drip Leg Diameter and Leg Length) with respect to main steam piping size. Fig. 3: Recommended Drip Leg Sizing A carefully designed drip leg enables steam traps to effectively drain the condensate from steam mains. For that, the drip legs should be large enough to allow the condensate to drop out of the steam at the pipe bottom. Recommended drip leg sizing table (Fig. 3) provides a good reference for such a scenario. In case the drip leg is not sized properly, the condensate will blow along with the steam without separating out as shown in Fig. 4. Fig. 4: Effect of Drip Leg Sizing Click here to know about Steam Traps: Steam Traps: Definition, Types, Selection, Features, Codes & Standards