K-factor for incompressible liquid One of the most typical questions asked by process or hydraulic engineers is what is the value of hydraulic resistance (K-factor) of piping component (fitting,...
Category: Piping Stress Analysis
In my last article on stress analysis of tank piping, I described the effect of tank bulging. Click here to refresh yourself on the effect of storage tank bulging. In this article, I will describe...
Pipe Stress Analysis Report Preparation for Issuing to the Client
Proper documentation of the stress calculation performed using Caesar II or any other stress analysis software is very important as the report or documents are the final deliverables to the client....
What is Severe Cyclic Conditions as per Process Piping Code ASME B31.3?
Severe cyclic is not a fluid service. It is a condition where fatigue failures are more likely so additional precautions against fatigue failure are taken. As per ASME B31.3, it is a condition...
What is a Pressure Vessel Clip? The attachments welded to the equipment by the vendor for bolting the brackets for pipe support are known as Pressure Vessel clips or Cleats. Fig. 1 shows typical...
The term TBE i.e, Technical Bid Evaluation is well-known to all piping engineers. Whenever any piping item is purchased from a vendor, before placing the final order, it is required to check the...