Skip to content
piping engineers blog
Search
  • Piping Design & Layout
  • Piping Stress Analysis
    • Piping Stress Basics
    • Caesar II
    • Start-Prof
  • Piping Supports
  • Piping Interface
    • Mechanical
    • Process
    • Instrumentation
    • Pipeline
    • Civil
    • Project Management
    • Construction
    • Plumbing
    • Health & Safety
    • Inspection and Testing
    • Maintenance
    • Oil and Gas-Energy
  • Engineering Materials
  • PDMS-E3D
    • PDMS
    • E3D
    • SP3D

Category: Piping Design Basics

link to Piping Nipples for Piping and Plumbing Industry

Piping Nipples for Piping and Plumbing Industry

In the piping and plumbing industry, a piping nipple is a pipe fitting, consisting of a short straight piece of pipe, usually provided with male pipe thread at both ends, for connecting two other...

Continue Reading
link to What are Control Valves? | Selection and Types of Control Valves

What are Control Valves? | Selection and Types of Control Valves

Control valves are control devices that are used to manage and control fluid flow, pressure, temperature, or liquid level by varying the flow passage size. In process systems of production wells, oil...

Continue Reading
link to Material Take-Off (MTO) & Processing for Piping System

Material Take-Off (MTO) & Processing for Piping System

A Material Take Off (MTO) is a process to study a drawing and find out all the materials required to construct the drawing in physical form. In each individual drawing, specific items are listed...

Continue Reading
link to Hydrostatic Test in Piping: Hydrotest Vs Pneumatic Test

Hydrostatic Test in Piping: Hydrotest Vs Pneumatic Test

A hydrostatic test or hydro test is a widely used method to ensure leak tightness and safety of pressure vessels, piping systems, pipeline systems, plumbing systems, tanks, boilers, cylinders, and...

Continue Reading
link to What is Severe Cyclic Conditions as per Process Piping Code ASME B31.3?

What is Severe Cyclic Conditions as per Process Piping Code ASME B31.3?

Severe cyclic is not a fluid service. It is a condition where fatigue failures are more likely so additional precautions against fatigue failure are taken. As per ASME B31.3, it is a condition...

Continue Reading
link to Piping Isometric Drawing Checklists | Isometric Checklist

Piping Isometric Drawing Checklists | Isometric Checklist

Piping Isometric drawing is one of the most important deliverables of the piping discipline as it provides complete information of the piping route to be erected at the construction site. So...

Continue Reading
« PREV Page 1 … Page 42 Page 43 Page 44 Page 45 Page 46 … Page 58 NEXT »

About Me

Hi There! Welcome to my space, I am Anup Kumar Dey, an experienced Piping and Pipeline engineer for the last 20 years. Through this platform, I will share my experiences and knowledge with you in an innovative way. So be with me for the next couple of years!

  • CONTACT
  • ABOUT
  • PRIVACY
  • ADVERTISE
  • DISCLAIMER
© 2025 Copyright What is Piping