Technical and General requirements for Spring Hangers while purchasing
In all critical process and power plant units’ the use of spring hangers are quite common. These are mostly used near equipment to bring nozzle loads within vendor-allowable values. Purchasing a...
Before connecting the process gas pipings with compressor nozzles, the shaft alignment work for the compressors and driver shall be carried out to ensure their concentricity. This concentricity...
Shell & Tube Heat Exchanger Piping | Online Course on Drums/Exchanger Layout & Stress Analysis
Shell & Tube Heat Exchangers are the most frequently used Heat Exchangers in Process Plants. The purpose of this presentation is to provide guidelines for Shell & Tube Heat Exchanger Piping...
Considerations for Hydrostatic Field Test of GRE lines The hydrostatic field test or hydraulic test on the GRP/GRE line, or on the section of it, is required to verify the hydraulic sealing of the...
A Pump or Pumping system is the major equipment in any process or power plant. So the equipment should operate properly to give the best output in terms of performance. However, there are many...
The thermal bowing phenomenon occurs when a horizontal pipe is filled partially by hot or cold fluid (LNG). Many thermal bowing occurrences cause unexpected damage to the piping or supporting...
